When using plastic chain plates, sometimes there will be a problem of spreading material. This problem is relatively common and difficult to avoid. There are many reasons for this, but the main one is to pay attention to maintenance in daily use.

1. Spreading material at the transfer point The material spread at the transfer point is mainly in the hopper, guide trough, etc. If the conveyor chain plate is seriously overloaded, the rubber apron of the guide chute of the conveyor chain plate is damaged, and the steel plate at the guide chute is designed to be far away from the belt. The above situation can be solved by controlling the transportation capacity and strengthening the maintenance oucan_show.

2. When the concave section belt is suspended, the concave section belt section will be suspended when the curvature radius of the concave section is small, and the belt will be suspended. At this time, the groove formation of the belt will change, because the belt has left the grooved idler group, and the general groove angle becomes smaller, so that some of the material spills out. Therefore, in the design stage, a larger radius of curvature of the concave section should be used as much as possible to avoid such a situation. For example, in the mobile mechanical ship loader and stacker-reclaimer equipment, in order to shorten the tail car, the concave section here is designed to be a transition zone without arc, and when the belt width is selected with a small margin, it is easier to spread the material.

3. Scattering when the belt is deviating. When the belt is deviating, the height of the two edges of the belt has changed, one side is high and the other side is low, and the material is scattered from the lower side. The processing method is to adjust Belt deflection.

In daily use, if you do a good job in maintaining the stainless steel chain plate, there will be no problem of spreading material, which indirectly saves the production cost.